Operation Manual

Effect parameters |585
h Panning Depth 0…100 Sets the panning width
Src Off…Tempo Selects the modulation source for the
panning width
Amt –100…+100 Set the modulation amount of the pan-
ning width
i Wet/Dry Dry, 1:99…99:1,
Wet
Balance between the wet and dry signal
Src Off…Tempo See DMS (Dynamic Modulation Source)
Amt –100…+100 Amount of modulation source
Tape Echo
This effect simulates a tape echo unit with three playback heads. The distor-
tion and tonal change typical of magnetic tape are also reproduced.
Wah Flatter
D
-mod
Tap2/3
Position
+
Tape
Saturation
Left
Right
FX Amt
Trim
PanLevel
FX Amt
FX Amt = 100: Mono In - Stereo Out / FX Amt = 0: Stereo In - Stereo Out
Feedback
Feedback Amt
High / Low DampPre Tone
Delay
(1)
(2)
(3)
Delay Time
a Delay (Tap1) [msec] 0…2700 Sets the delay time (tap1)
Src Off…Tempo Selects the modulation source of the delay
time
Amt –2700…
+2700
Sets the modulation amount of delay time
b Tap2 Position [%] 0…100 Sets the position of Tap 2 relative to the
Tap 1 delay time the depth of pitch variation
c Tap3 Position [%] 0…100 Sets the position of Tap 3 relative to the
Tap 1 delay time the depth of pitch variation
d Tap1 Level 0…100 Sets the Tap1 output level
Pan L, 1…99, R Sets the stereo image of tap1
FB Amt –100…+100 Sets the Tap1 feedback amount