Operation Manual

Effect parameters |707
Mic Model+PreAmp (Mic Modeling + PreAmp)
This effect simulates a mic and vacuum tube preamp. You can choose from
various types of mic and positions to create differing sonic characters.
+
Tube Pre AmpMic Simulation
Left
Right
FX Amt
Output Level
FX Amt
FX Amt = 100: Mono In - Mono Out / FX Amt = 0: Stereo In - Stereo Out
a Mic Type Vintage Dynamic, Multi
Condenser, Percussion
Condenser, Drums
Dynamic,
Vocal Dynamic,
Multi Dynamic, Vocal
Condenser, Vocal Tube,
Kick Dynamic
Selects the type of mic
b Mic Position Close, On, Off, Far Sets the mic placement dis-
tance
c Tube Low Cut [Hz] Thru, 21…8.00k Sets the frequency of the low
cut filter
High Cut [Hz] 53…20.00k, Thru Sets the frequency of the high
cut filter
d Tube Gain [dB] –24.0…+24.0 Sets the input gain to the vacu-
um tube preamp
Saturation [%] 0…100 Sets the input/output re-
sponse of the preamp
e Tube Bias 0…100
Sets the bias level of the preamp
f Tube Output Level [dB] –48.0…+0.0 Sets the output level of the
preamp
g Wet/Dry Dry, 1:99…99:1, Wet Balance between the wet and
dry signal
Src Off…Tempo See DMS (Dynamic Modulation
Source)
Amt –100…+100 Amount of modulation source
b: Mic Position
This expresses the effect that the mic position has on the sound. The Close
setting is the closest mic position, and the Far setting is the farthest.