Operation Manual

Effect parameters |759
a: Scratch Source
b: Response
The Scratch Source parameter enables you to select the modulation source
that controls simulation. The value of the modulation source corresponds to
the playback position. The Response parameter enables you to set the speed
of the response to the modulation source.
+ Max
Zero
Scratch!
D
-mod
– Max
JS X
Ribbon
JS+Y
JS–Y
etc…
Zero
+ Max
Scratch Source
Recorded Sound
Scratch Source
Startabac oition nd
c: Envelope Select
c: Src
d: Threshold
When “Envelope Select” is set to D-mod, the input signal will be recorded
only when the modulation source value is 64 or higher.
When “Envelope Select” is set to Input, the input signal will be recorded only
when its level is over the Threshold value.
The maximum recording time is 2,730msec. If this is exceeded, the recorded
data will start being erased from the top.
e: Response
This parameter enables you to set the speed of the response to the end of
recording. Set a smaller value when you are recording a phrase or rhythm
pattern, and set a higher value if you are recording only one note.
f: Direct Mix
With Always On, a dry sound is usually output. With Always Off, dry sounds
are not output. With Cross Fade, a dry sound is usually output, and it is muted
only when scratching.
Set Wet/Dry to 100 to use this parameter effectively.