Operation Manual

System Configurations
18 Korg 1212 I/O
English
Below is a nifty little diagram, showing the 1212 I/O hooked up in a simple
system with two ADATs and a BRC. If you have more ADATs than shown
here (lucky you!), just pretend that this diagram’s ADAT #2 is the last one
in your chain.
ADAT Timecode Conditioner
The 1212 I/O’s ADAT Timecode Conditioner is a small device which fits
between the ADAT 9-pin sync cable and the 1212 I/O’s ADAT timecode
connector. This device pre-conditions the ADAT timecode, enhancing the
1212 I/O’s timecode sync capabilities.
If you will be using ADAT timecode with the 1212 I/O, please make sure
that the ADAT Timecode Conditioner is connected between the ADAT sync
cable and the ADAT sync connector on the 1212 I/O’s ADAT sync input.
The 1212 I/O with 2 ADATs and a BRC
SyncOptical
SyncOptical
SyncOptical
Word
Clock
Word Clock
BRC
ADAT #1
ADAT #2
1212
I/O