Operation Manual
Installation
Korg 1212 I/O 5
English
All jumpers within a group must be set the same way: either all installed,
or all removed.
5. If you have removed any jumpers, store them in a safe place.
They’ll be necessary if you ever want to switch the card back to -10dBv
operation.
Installing the 1212 I/O card in your computer
Please consult your compatible computer’s manuals for detailed
instructions on installing a card in your specific system. The instructions
below are a brief overview of the installation procedure.
1. If you have not done so already, read “Analog levels: +4 or -10” on
page 3, and set the 1212 I/O’s levels as desired.
2. Shut down the computer.
3. Detach the power cable from the computer.
4. Remove the computer’s main cover.
5. Choose any available PCI slot.
For each slot, there is a small port on the back of the computer, which
allows access to one end of the card (in the case of the 1212 I/O, this is the
jack panel, into which you plug all your digital and analog connectors).
There will be a small cover over the port.
6. Remove the cover from the port on the back of the computer.
7. Before handling the 1212 I/O card, touch a grounded metal surface
(such as your computer’s power supply). Follow the complete
instructions under “Handle carefully!,” on page 2.
8. Before plugging the card in, align it with the selected PCI slot.
The jack panel should line up with the port on the back of the computer.
There also should be a corresponding guide towards the front of the
computer, to hold the other end of the card in place.
9. Press the card gently but firmly into the slot, until the connector is
fully inserted.
Don’t force the card into the slot. If you encounter a lot of resistance, pull
the card out and try inserting it again.
10. To make sure that the connector is properly inserted, pull on the
card gently.
If the card resists your gentle pull and stays in place, then it’s inserted
properly.
If it moves easily, then go back to step 9 and try again.
11. After installing the card in the slot, replace the computer’s main
cover and power cable.