Operation Manual

18
Dispose of the unit in accordance with EC Directive 2002/96/EC – WEEE
(Waste Electrical and Electronic Equipment).
If you have any questions, please contact the local authorities responsible for waste
disposal.
14 What if there are problems?
If the scale detects and error when measuring, the following is displayed.
Display Cause Remedy
Err The maximum load capacity of
150kg was exceeded.
Do not load the unit with over
150kg.
Lo The batteries are almost empty. Replace the batteries.
no Accessing a user storage location in
which no values have been saved.
The scale will switch o automati-
cally after a short while; switch the
scale on again and proceed with the
measurements.
– – – – Scale is searching for correct zero
point.
Place the scale on a secure, fl at
surface. Wait until “0.0 kg” is
displayed.
No measurement possible
Possible errors Remedy
If you stand on the scale to measure your
values before the display shows “0.0 kg”, the
scale will not function correctly.
Correctly activate the scale (wait for
“0.0 kg” to be displayed) and repeat the
measurement.
The batteries in the scale are empty. Replace the batteries.
Incorrect weight measurement
Possible errors Remedy
Scale is on carpeting. Place the scale on a level and solid surface.
Incorrect zero point of scale. Switch on the scale and wait until the scale
automatically switches o again (do not step
onto the scale before then). Then switch on
the scale again and repeat the measurement.