Manual

14
If your weapon is equipped with an exchangeable front sight system, you have the
option to change different front sights.
Beyond the standard equipment, you can additionally order individually shaped sights.
The exchangeable front sights are installed via an Allen screw located at the muzzle of
the barrel.
The screw in the barrel rib is unscrewed by approximately .158" (4mm) with the
included .059" (1.5mm) Allen wrench. Then, the front sight can be taken out of the rib.
During removal, as well as during inserting, the position of the holding pin should not
be changed. The Allan screw is tightened by screwing it with moderate pressure
against the front sight. The tight fit of the exchanged front sight has to be checked
occasionally during shooting.
8.5 Summary of rear sight adjustment
Combat sights:
in the case of shooting low (Æ) clockwise adjustment is required
in the case of shooting high (Å) counter-clockwise adjustment is required
in the case of shooting left - loosen left, tighten right
in the case of shooting right - loosen right, tighten left
to loosen (Å) to tighten (Æ)
Sport- and Target sights:
in the case of shooting low (Å) counter-clockwise adjustment is required
in the case of shooting high (Æ) clockwise adjustment is required
in the case of shooting left (Å) counter-clockwise adjustment is required
in the case of shooting right (Æ) clockwise adjustment is required
9. Grip replacement
The grip screws can be removed either from the right or from the left side. Because of
the function of the opposite side as a screw nut, the rotation of the screw from that side
has to be accomplished with a second screwdriver.
After removal of the grip screws, a small pin is inserted at an angle to where the
previous grip screw was removed. Via this method, the opposite side of the grip is
loosened from the frame without damage. The second grip plate can then be easily
taken off.
If the weapon is used alternatively with standard- or match grips, it is necessary to
exchange the lower retaining pin (part #65) as well. This pin can be driven laterally
from the frame. The included locating pin, that is abbreviated on one side, has to be
inserted in a way that it sticks out only on the left side of the frame (left = the cover
plate side). For the left handed match grip the assembly is done on the right side.
After loosening the retaining screws, the target grips are pulled apart in parallel. This is
necessary, because of the additional pinning. Both halves should not be loosened from
each other by force or tilting. Damage or worse yet, breakage will result.
10. Accessories
10.1 Barrel weight