Manual

Adjusting the Single-Action trigger weight

Simultaneously

Left side - hold the trigger spring stud screw

Right side - loosen the secondary side screw, then adjust the trigger

spring stud screw slightly and retighten the right side clamp screw.

3.3 Trigger stop

The travel way of the trigger in the Single-Action mode is stopped by an adjustable

trigger stop screw. This screw is located in the trigger guard behind the trigger. The

protruding length of the trigger stop screw can be varied with the included .059"

(1.5mm) Allen screw . Turning the screw clockwise into the frame increases the travel

way of the trigger after release of the hammer. This travel way is decreased by

unscrewing (counter-

clockwise) the trigger stop screw. Unscrewing the screw too far, can cause problems

during the release of the trigger. In the extreme case, the shot cannot be released or

the hammer won’t be cocked.