Manual

6
Adjusting the trigger stop screw
4. Double-Action function
In this mode, the hammer is cocked by pulling the trigger. The maximum trigger weight
is 158.6oz (4500g = 44.15N). Rimfire weapons can have a slightly higher trigger
weight.
Please notice!
During DA-(Double Action) mode, it is absolutely necessary that the trigger reaches its
foremost position before you pull the trigger again. If you pull the trigger too early,
meaning during the forward movement, the cylinder might rotate without cocking the
hammer.
4.1 Changing the pressure point of the Double-Action trigger
The Double-Action travel of the trigger can be equipped with a pressure point. This
mode allows for the conscious target correction, briefly before the release of the shot.
Pressure point adjustment is effected by exchanging small steel rollers of varying
diameters. These rollers are inscribed with numbers from #3 to #1. The diameter varies
by a few thousandths of an inch (100th of a mm). Insertion of roller #3 will yield a
recognizable pressure point, which will increase with the insertion of roller #1.In this
way, the shooter can individually adjust the pressure point to their personal desire.
Wheel #3 is installed by the factory. This yields in an absolutely smooth hammer travel
with a trigger weight of approx. 158.6oz (4500g = 44.15N).
4.2 Roller replacement