Manual

the trigger is fully cocked. The proper function of the safety is directly connected to the

correct movement of the trigger. A delayed trigger, e.g. due to a contamination or due

to a trigger return spring that has been tensioned insufficiently, can influence the

function of the safety.

Please notice :

Do not decrease the SA-trigger weight remarkably below 35.2oz (1000g), because not

only the pre-travel, but also the function of the safety is influenced.

6. Loading and unloading

Contrary to most cylinder release levers located at the side, our revolver has the

cylinder release lever to the right of the hammer. The advantage of this design is the

faster and easier handling of the revolver. The cylinder release lever is pushed by the

thumb in the direction of the muzzle. The index finger of the right hand then pushes the

cylinder to the left and out of the frame. The shells are emptied out by operating the

cylinder locking bolt via the left hand. The cylinder locking bolt, serving as an ejector, is

pushed aft into the cylinder. When the reloading is completed with the left hand, the

positioning of the revolver in the right hand has never changed.

Release and opening of the cylinder Loading the cylinder

The cylinder should be fixed in the open position during the unloading process or while

using the ejector.For this, one can grab the cylinder with one or two fingers of the left