Installation Instructions

Flush Mount Box
If the switch will be mounted to the surface of the drywall using the flush mount box, use
the following procedure:
Attach the flush mount frame to the wall using the provided hardware.
Insert the wireless switch into the frame and use the provided screws to connect the switch
to the frame. Use the pinhole on the back of the switch to determine the up orientation - the
pinhole should be on the top side when installed correctly.
Put the cover box on the switch and fasten with the provided screw.
Quick Mount Box
Cut a hole in the drywall using the provided template.
Insert the quick connect box and secure by pushing the latching tab down securely.
Remove the grounding lug from the wireless switch by snapping the tab at the scored mark.
Insert the the switch into the quick connect box and push down to secure the unit.
Place the cover plate over the switch and screw on to secure the unit.
Regulatory Declarations
Warning Changes or modifications not expressly approved by Katerra Inc. could void the
user’s authority to operate the equipment.
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation,
Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to
the following two conditions:
1. This device may not cause interference.
2. This device must accept any interference, including interference that may cause undesired
operation of the device
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and