Manualshelf

Installation Sheet

ManualsBrandsKovacs ManualsInterior PendantsKovacs Spiked 6 Light 18" Wide Pendant with Clear Glass Bar Accents
1
ASSEMBLY THE FIXTURE (FIG. 1)
1. Shut off the power at the fuse box or circuit breaker. If
necessary, remove the existing fixture and its mounting
hardware from the ceiling.
2. Carefully unpack your new fixture and lay out all the parts in a
clear area. Take care not to lose any small parts necessary for
installation.
3. Determine the rod length if necessary, then assemble the rod
(C) together using nipple (E), then assemble the small rod (D)
onto the rod (C), after that, assemble the bottom end of the
rod (D) onto the coupling (B) and assemble the small loop (F)
onto the top end of the rod (C).
4. Assemble the crystal bar (A) onto nipple (O) well.
5. Install the bulb (N) (not included) in accordance with the
fixture’s specifications. (DO NOT EXCEED THE MAXMUM
WATTAGE RATING!) (NE PAS DEPASSER LA PUISSANCE
NOMINALE MAXIMALE!).
6. Connect the small loop (F) and (I) using the chain quick link
(G) well.
7. Attach the cross bar (M) to the outlet box using the outlet box
screws (K). The side of the mounting bar marked “GND” must
face out.
8. Follow the wiring instructions carefully (See Fig.2).
9. Attach the fixture main body onto outlet box by protruding
mounting screws (L) through mounting holes on the canopy
and secure with ball nut (J).
CONNECTING THE WIRES (FIG. 2)
10. Connect the electrical wires as follows. Connect the smooth
wire from the fixture to the smooth (HOT) house wire.
Connect the ribbed wire from the fixture to the ribbed (Neutral)
house wire. Make sure all the wire nuts were secured. You
may wrap the connections with electrical tape. If your outlet
box has a ground wire (Green or Bare Copper) connect
fixture’s ground wire to it. Other wise attach the bare copper
fixture wire to the green ground screw on the mounting bar.
11. Tuck the wire connections neatly into the ceiling junction box.
Your installation is now complete. Turn on the power supply of
the junction box to test the fixture.
Fig.1
K
M
L
J
I
G
F
C
E
B
A
O
H
N
D
INSTALLATION INSTRUCTION FOR FIXTURE #P1791, P1792
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
Set A#A-010
-Crossbar
-Ground Screw
-Mounting screws (2)
12” ROD
W30-1-416
W30-1-077

Summary of content (1 pages)