Instruction Manual

INSTALLATION INSTRUCTIONS
05/10/2012
READ AND SAVE THESE INSTRUCTIONS
WAR NI NG ! S H UT P OWER OFF AT F US E O R CI RC UI T BRE AKE R.
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
Fig. 1
Fig. 2
HANGING THE FIXTURE (Fig. 1)
1. Carefully remove the fixture from the carton and check
that all parts are included as shown in the illustration.
2. Shut off power at the circuit breaker and remove old
fixture including the crossbar.
3. Attach the Crossbar (A) to the Outlet Box using the two
screws (C). The side of the Crossbar marked “GND”
must face out.
4. Thread two Threaded Studs (B) 1/4” into the pre-drilled
holes in the Crossbar (A) spaced the same distance
apart as the hole in the Canopy (D).
5. Place Glass Shade (G) over the Metal Ring (I). Bring
the Metal Ring (I) and Glass shade (G) as illustrated to
attach to Holder (F). Secure the combination (G) (I)
and (F) using Screws (H).
CONNECTING THE WIRES (Fig. 2)
6. At this point, connect the electrical wire as shown in
figure 2, making sure that all wire connectors are
secured. If your outlet has a ground wire (green or bare
copper), connect the fixtures Ground Wire to it.
Otherwise, connect the fixture Ground Wire directly to
the crossbar using the Green Screw provided.
FINISHING THE INTALLATION (Fig. 1)
7. After the wires are connected, carefully tuck them
inside the outlet box, then place Canopy (D) over
Threaded Studs (B) and secure it tightly with Knurled
Knobs (E).
8. Install the light bulb in accordance with the fixture’s
specifications. (DO NOT EXCEED THE MAXIMUM
WATTAGE RATING!) (NE PAS DEPASSER LA
PUISSANCE NOMINALE MAXIMALE!)
Your installation is now complete. Return power to the
junction box and test the fixture.
Note: Illustration (Fig. 1) on this manual is for
installation purposes only. It may or may not be
identical to the fixture purchased
LA-1033E
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
White or
Ribbed
HOUSE
WIRES
White
(Neutral)
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
Green
(Ground)
IMPORTANT: FIXTURE SHOULD BE INSTALLED BY
A QUALIFIED ELECTRICIAN TO ENSURE PROPER
WIRING AND INSTALLATION.
F
E
G
H
I
C
B
A
D