Belle swing chair Assembly Manual Kozyard LLC Products © Copyright 2016 - 2019 Kozyard LLC. | All Rights Reserved.
ASEEMBLY INSTUCTION BEFORE ASSEMBLING,MAKE SURE THAT YOU LAY OUT AND IDENTIFY ALL PARTS LISTED BELOW IN THE PARTS LIST. INSTALL ON LEVEL GROUND. INSTALL NOT LESS THAN 6 FEET FROM ANY OBSTRUCTION SUCH AS FENCE, GARAGE,HOUSE, OVERHANGING BRANCHES, LAUNDRY LINES,OR ELECTRICAL WIRES. TIGHTEN ALL NUTS AND BOLTS SECURELY.ALL BOLTS SHOULD BE HAND TIGHENED BEFORE USE.NEVER USE POWER TOOLS OR EXCESSIVE FORCE DURING ASSEMBLY AND TIGHTENING OF BOLTS.
Part list LEG TUBE AX2 LEG TUBE TOP CROSS BAR BX2 CX1 LEG CROSS HANGING PIPE EX2 E1X4 SPRING HOOK HX2 CANOPY TUBE ARMREST IX2 CANOPY TUBE BACK LEG CROSS FX1 SEAT FRAME TOP CROSS BAR DX1 BACK LEG CROSS GX1 BACK FRAME JX1 J1X1 CANOPY BOLT KX2 LX2 MX1 BOLT BOLT BOLT PX2 QX2 RX4 BOLT BOLT TX2 NX2 BOLT UX4 OX1 BOLT SX4 BOLT VX2
Part list NUT WASHER M6X15 M8X8 W ALLEN KEY PLASTIC SCREW PLASTIC END CAP M6X15 M8X8 M6X15 M8X8 X WRENCH YX2 Z
STEP -1 Connect part D and part C to build the beam using bolt Q washer X,nut W and plastic end-cap Z as shown in diagram. STEP -2 Connect part A and part B with beam using bolt U washer X,nut W and plastic end-cap Z as shown in diagram. Attention:Both part A should be the sime side,and both part B should be in the other side.
STEP -3 Connect part E and legs (part A&B) using bolt R washer X,nut W and plastic end-cap Z as shown in diagram. STEP -4 Connect part G and part F to build a connection tube for the rear foot using bolt O,washer X,nut W and plastic end-cap Z as shown in diagram.
STEP -5 STEP -6 Connect the rear foot tube with part B using bolt S washer X,nut W and plastic end-cap Z as shown in diagram. Set up seat&back together 1.Connect part J1 and part J together using bolt N,washer X,nut W and plastic end-cap Z as shown in diagram. 2.Connect part I and part J using bolt T washer X,nut W and plasticend-cap Z as shown in diagram.
STEP -7 1.Connect part E1 with backseat (part J1)using bolt V,washer X,nut W and plastic end-cap Z as shown in diagram. 2. Connect part E1 to armrest (part I) using bolt P,washer X,nut W and plastic end-cap Z as shown in diagram. STEP -8 Use part H to hook the seat to the frame.
STEP -9 STEP -10 Affix part K to beam using screw Y. Insert part L to canopy.
STEP -11 Connect Part L and Part K to support canopy.
Kozyar 10808 6th St Ste 100 Rancho Cucamonga CA 91730