Safety Data Sheet

Product Name: Kozyvacu Premium Deep Vacuum Pump Oil
Revision Date: 20-January-2021
Page 3 of 8
GHS and under Directive 2001/58/EC and other international
FIRE FIGHTING
Fire Fighting Instructions: Evacuate area. Prevent run-off from fire control or dilution from entering
streams, sewers or drinking water supply. Fire-fighters should use standard protective equipment and
in enclosed spaces, self-contained breathing apparatus (SCBA). Use water spray to cool fire exposed
surfaces and to protect personnel.
Hazardous Combustion Products: Smoke, Fume, Carbon Monoxide, Aldehydes,
FLAMMABILITY
PROPERTIES
Flash Point ASTM D92 (open cup typical)
Flammable Limits
(Approximate volume %
in air): LEL: N/D UEL:
N/D
Autoignition Temperature: N/D
°C (°F)
VAC 46
216 (420)
VAC 68
240 (464)
VAC 100
260 (500)
SECTION 6 : SPILL OR LEAK HANDLING PROCEDURES
SPILL MANAGEMENT Land Spill: Stop leak if you can do so without risk. Recover by pumping or with suitable absorbent.
Water Spill: Stop leak if you can do so without risk. Confine the spill immediately with booms. Warn
other shipping. Remove from the surface by skimming or with suitable absorbents. Seek the advice of
a specialist before using dispersants.
Water spill and land spill recommendations are based on the most likely spill scenario for this material;
however, geographic conditions, wind, temperature, (and in the case of a water spill) wave and current
direction and speed may greatly influence the appropriate action to be taken. For this reason, local
experts should be consulted. Note: Local regulations may prescribe or limit action to be taken.
ENVIRONMENTAL Large Spills: Dyke far ahead of liquid spill for later recovery and disposal. Prevent entry into
PRECAUTIONS waterways, sewers, basements or confined areas.
SECTION 7 : HANDLING AND STORAGE
HANDLING
Prevent small spills and leakage to avoid slip hazard.
Static Accumulator: This material is a static accumulator.
STORAGE
Do not store in open or unlabeled containers.
SECTION 8 : EXPOSURE CONTROLS / PERSONAL PROTECTION
Exposure limits/standards for materials that can be formed when handling this product: When mists / aerosols can occur, the
following are recommended: 5 mg/m³ - ACGIH TLV, 10 mg/m³ - ACGIH STEL.
Note: Information about recommended monitoring procedures can be obtained from the relevant agency(ies)/institute(s)
ENGINEERING CONTROLS
The level of protection and types of controls necessary will vary depending upon potential
exposure conditions. Control measures to consider:
No special requirements under ordinary conditions of use and with adequate ventilation
PERSONAL PROTECTION
Personal protective equipment selections vary based on potential exposure conditions such as
applications, handling practices, concentration and ventilation. Information on the selection of
protective equipment for use with this material, as provided below, is based upon intended,
normal usage.