Installation Guide

10
FINETUNING
At times, you may have to fine-tune your cabinetry after the installation. After all the cabinets have been installed plumb and level, place doors and
drawers back on the cabinets. Install doors and make hinge adjustments so reveals between doors and drawers are equal. Make these adjustments
before installing pulls or knobs.
COMMON SERVICE PROBLEMS YOU CAN HANDLE
The Troubleshooting Guide (below) will help you fix the most common problems. Other adjustment information is included later in this guide.
CABINETRY INSTALLATION, CARE AND CLEANING
TROUBLESHOOTING GUIDE
CONDITION
Double doors on cabinet do not
line up.
Door does not fit up to cabinet face
frame at either top or
bottom.
Drawer face does not fit flush
with cabinet.
POSSIBLE CAUSE
• Cabinet not set level and
square (racked).
• Hinge out of adjustment or
cabinet racked.
• Door warped due to extreme
dryness or humidity.
REMEDY
• Loosen screws and use shims to
make cabinet plumb.
• Loosen hinge screws and readjust.
• Make sure cabinet is plumb and level.
Then, reset hinge.
• Relative humidity level should be at least 35%.
Install proper control in home. If the door has
already warped, leave door partially open and it
should adjust itself.
• Pull out drawer. Rotate the tilt adjustment lever
on the rear of each runner to tilt the drawer
front.
• Close drawer. Drawer should automatically
reset.
• Drawer glide out of
alignment.
Scratches, nicks and dents.
• Touch-Up Kit
• Mishandling.