Installation Guide

17
CABINETRY INSTALLATION, CARE AND CLEANING
LAZY SUSAN ADJUSTMENTS
There are three possible adjustments on the lazy susan unit.
Uneven or Incomplete Door Closing (A)
Open the cabinet door and locate the white plastic collar (1) at the top of the telescopic pole.
You must loosen the Phillips head screw (2) on this collar. Next, slowly rotate the entire shelf unit
and door in a counter-clockwise direction until the collar catches on the catch latch on the
back of the ceiling bracket. This catch position is very subtle and could be difficult to detect.
Next, slowly rotate the door clockwise (noting that the collar should be kept in a fixed
position), to the exact front centered position, but not past it. If past center, make another
revolution. DO NOT TURN BACK IN A COUNTER-CLOCKWISE DIRECTION until a setting has
been made. Now, SLOWLY re-rotate the assembly in a counter-clockwise direction far enough so
that the collar screw faces you again. Retighten the screw.
Top and Bottom Clearance (B)
With a completely empty cabinet, remove the plastic retainer clip (1) at the bottom of the telescopic pole. Turn the thumbscrew adjustment wheel (2),
located in the cut out portion of the shaft. Clockwise rotation will raise the door end unit; counter-clockwise rotation will lower the unit. (Each full turn
raises or lowers the door 1/32”.) Once you have achieved the desired height, replace the retainer clip.
Insufficient Side Clearance (C)
Begin by outlining the top and bottom brackets with a pencil to establish a reference point.
Top: Remove the setscrews (1). Loosen the star washers (2). Re-center the pivot and realign the pole. Tighten the star washers and check for position.
Replace the setscrews after making the adjustments.
Bottom: Open the door to the left to reveal the bottom bracket. Remove the setscrew (3) and loosen the star washer (4). Now open the door to the
right and repeat this operation. Re-center the pivot, tighten the star washers and replace the setscrews.
(A)
DOOR CLOSING ADJUSTMENT
(B)
ADJUSTING TOP AND
BOTTOM CLEARANCE
(C)
SIDE CLEARANCE ADJUSTMENT