User Manual

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Your Digital Audio Transcoder
4
# Feature Function
8 OUT Detachable
Terminal Block
Connect to the digital audio acceptor
9
AES/
EBU
IN Detachable
Terminal Block
Connect to the digital audio source
10 OPTICAL Button
Press to select the optical input source
11 S/PDIF Button
Press to select the S/PDIF source
12 AES-ID3 Button
Press to select the AES-ID3 source
13
LOCAL INPUT
SELECTOR
AES/EBU Button
Press to select the AES/EBU source
14 TWISTED PAIR / LOCAL
Push Button
Release the button, to the LOCAL position, if a single
unit is used, or the unit is to operate as a transmitter
1
Push the button in, to the TWISTED PAIR position, if
the unit operates as a receiver
1
15 OPTICAL TosLink®
Connector
Connect to the digital audio source
2
16 S/PDIF RCA
Connector
Connect to the digital audio source
17
INPUTS
AES-ID3 BNC
Connector
Connect to the digital audio source (75)
18 ON LED Lights red when the system is powered
19 LINK LED Lights green when the input is connected and the
signal is of good quality and can be decoded
Figure 2: 466 Digital Audio Transcoder Underside Mode Selection Switch
Table 2: 466 Underside Features
# Feature Function
1 MODE SELECT Switch Slide up to set to PROF. (professional) or slide down to set
to CONSUMER to change the system bit
3
1 See Figure 4
2 Use an optical cable, such as Sony’s POC-15A (not included in the package)
3 For example, when connecting a consumer source (a DVD player) and outputting to a professional acceptor (a DAT
recorder), it may be necessary to change the system bit status by altering the selected PROF./CONSUMER mode