Owner manual

711N, 712N - Connecting the 711N and the 712N 7
7
5 Connecting the 711N and the 712N
Always switch off the power to each device before connecting it to your
711N/712N. After connecting your 711N/712N, connect its power and
then switch on the power to each device.
You can use the 711N and 712N to configure a Video-Audio Transmitter and Receiver
system.
To connect the 711N Video-Audio Line Transmitter with the 712N Video-Audio Line
Receiver, as illustrated in the example in
Figure 3, do the following:
1. Connect a composite video source (for example, a composite video player) to
the VIDEO IN BNC connector on the 711N, and connect an unbalanced
stereo audio source to the AUDIO IN RIGHT and LEFT RCA connectors.
2. On the 712N, connect the VIDEO OUT BNC connector to a composite video
acceptor (for example, a display).
3. Connect the LINE OUT connector of the 711N to the LINE IN connector of
the 712N, via UTP cabling.
4. If an additional output is required, connect the LINE LOOP connector on the
712N to the LINE IN connector of an additional 712N unit, via UTP cabling.
By connecting the LINE LOOP connector of the additional 712N to the LINE IN
connector of a third 712N, you can further increase the number of outputs
5. On each 711N / 712N unit, connect a 12V DC power adapter to the power
socket and connect the adapter to the mains electricity.
See section 3.1 for the power connect feature
6. If required, on the 712N, adjust the VIDEO GAIN and EQ. levels, by inserting
a screwdriver into each of the small holes and carefully rotating them.
i