Manual

FC-10ETH – Configuring the FC-10ETH Ethernet Controller
11
4.2 Installing and Configuring the FC-10ETH
To configure the FC-10ETH via the ETHERNET, do the following:
1. Connect the FC-10ETH as described in Section 4.1 (see Figure 7)
2. Click the appropriate shortcut in the Start menu’s Programs folder.
The FC-10ETH Configuration Manager window (see Figure 8) opens.
3. Click the Search button to automatically search for devices (or the Search
Board command on the Action menu).
The MAC Address for the found “FC-10ETH” appears in the Device List.
4. Change the settings according to your network requirements and then click
the Config button (or the Config command on the Action menu) to apply the
settings.
Note that clicking the Config button will alter the IP settings of the
FC-10ETH.
Figure 7: Connecting the FC-10ETH for Configuration
i