K R A ME R E LE CT R O N IC S L T D .
Contents 1 Introduction 1 2 2.1 Getting Started Achieving the Best Performance 2 2 3 3.1 3.
1 Introduction Welcome to Kramer Electronics! Since 1981, Kramer Electronics has been providing a world of unique, creative, and affordable solutions to the vast range of problems that confront video, audio, presentation, and broadcasting professionals on a daily basis.
2 Getting Started We recommend that you: • Unpack the equipment carefully and save the original box and packaging materials for possible future shipment • Review the contents of this user manual • Use Kramer high-performance, high-resolution cables i 2.1 Go to http://www.kramerelectronics.com to check for up-to-date user manuals, application programs, and to check if firmware upgrades are available (where appropriate).
3 Overview The Kramer FC−31xl is a high−performance format converter for computer graphics signals with resolutions up to and including WUXGA. The unit converts a computer graphics input to a DVI−D output. The following table lists the resolutions supported by the FC-31xl.
3.1 Defining the FC-31xl UXGA to DVI Converter This section defines the FC-31xl. Figure 1: FC-31xl UXGA to DVI Converter # 3.
To adjust the vertical position (Vs) of the image, set the DIP-switches as required, according to the next table.
The SHARPNESS DIP-switch setting controls the phase of the sampling clock, as defined in the next table.
4 Connecting the FC-31xl i Always switch off the power to each device before connecting it to your FC-31xl. After connecting your FC-31xl, connect its power and then switch on the power to each device. To connect your FC-31xl UXGA to DVI Converter, as the example in Figure 3 illustrates, do the following: 1. Connect a computer graphics source (for example, a computer) to the UXGA IN connector. 2. Connect the DVI OUT connector to a DVI projector. 3.
5 Technical Specifications INPUT: 1 UXGA on a 15-pin HD connector OUTPUT: 1 DVI (On a DVI-I connector. Note that only a DVI-D signal is available on the DVI connector), 1.
6 EDID Factory Default Data The FC-31xl is shipped with a fixed, factory default EDID as shown in this section. Time: 8:56:25 AM Date: 07 December, 2010 EDID Manager Version: 1.0.0.
1280x800 @ 60 Hz (16:10 Aspect Ratio) 1280x960 @ 60 Hz (4:3 Aspect Ratio) 1280x720 @ 60 Hz (16:9 Aspect Ratio) (54-71) Detailed Descriptor #1: Preferred Detailed Timing (1920x1080 @ 60Hz) Pixel Clock : 148.
(108-125) Detailed Descriptor #4: Detailed Timing (1600x1200 @ 60Hz) Pixel Clock: 162 MHz Horizontal Image Size: 530 mm Vertical Image Size: 300 mm Refresh Mode: Non-interlaced Normal Display, No Stereo Horizontal: Active Time: 1600 Pixels Blanking Time: 560 Pixels Sync Offset: 64 Pixels Sync Pulse Width: 192 Pixels Border: 0 Pixels Frequency: 75 kHz Vertical: Active Time: 1200 Lines Blanking Time: 50 Lines Sync Offset: 1 Lines Sync Pulse Width: 3 Lines Border: 0 Lines Digital Separate, Horizontal Polarity
12 FC-31xl - EDID Factory Default Data
For the latest information on our products and a list of Kramer distributors, visit our Web site where updates to this user manual may be found. We welcome your questions, comments, and feedback. Web site: www.kramerelectronics.com E-mail: info@kramerel.
