User Manual

Connecting the FC-32 DVI to PC/Component Converter

5 Connecting the FC-32 DVI to PC/Component Converter

To connect the FC-32, as the example in Figure 2 illustrates, do the following

1. Connect the digital input source (such as, a computer graphics source) to the

24-pin Molex INPUT connector.

2. Connect an output acceptor (such as, a computer graphics VGA display or

component display) to the PC/COMPONENT OUT 15-pin HD

connector.

3. Set the front panel switch (see

Figure 1) to Y/PB/PR for a component

acceptor or to RGB for a computer graphics acceptor.

4. Connect the 5V DC power adapter to the power socket and connect the

adapter to the mains electricity.

Figure 2: Connecting the FC-32 DVI to PC/Component Converter

6 EDID

The FC-32 is shipped with a fixed, factory default EDID (see Section 8).

1 Switch off the power on each device before connecting it to your FC-32. After connecting your FC-32, switch on its power

and then switch on the power on each device