Manual

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Your FC-4002 Format Converter / TBC
4
Table 1: Front Panel FC-4002 Format Converter / TBC
# Feature Function
1 POWER Switch Illuminated switch for turning the unit ON or OFF
2 FINE Trimmer
3
SYNC
PHASE
COARSE Trimmer
Adjusts
1
the sync phase level
4 FINE Trimmer
5
SCH
COARSE Trimmer
Adjusts
1
the horizontal-to-subcarrier phase level
6 Y/C Button Selects the s-Video source for conversion
7 CV Button Selects the composite video source for conversion
8 RGB/S Button Selects the RGB/S source for conversion
9
INPUT
SELECTOR
YUV Button Selects the YUV source for conversion
10 LOCK Button
2
Disengages the front panel buttons
11 FREEZE Button Freezes the output video
12 GENLOCK Button Press to enable GENLOCK operation
Table 2: Rear Panel FC-4002 Format Converter / TBC
# Feature Function
13 LOOP BNC Connector Connects to the next Genlocked unit
14 SYNC BNC Connector Connects to the Genlock source
15 Term Button
Press to terminate the Genlock source (75) or release for looping
3
16 CV BNC Connector Connects to the composite video source
17 Y/C 4p Connector Connects to the s-Video (Y/C) source
18 G/Y BNC Connector
19 R/R-Y BNC Connector
20 SYNC BNC Connector
21
INPUTS
B/B-Y BNC Connector
Connects to the RGB (connect all 3 connectors: R/R-Y, G/Y, and
B/B-Y),
or YUV (connect all 3 connectors: R/R-Y, G/Y, and B/B-Y),
or RGBS (connect all 4 connectors: R/R-Y, G/Y, and B/B-Y, and
SYNC)
video source
22 CV/R/R-Y BNC Connector
23 G/Y BNC Connector
24 SYNC BNC Connector
25
OUTPUTS
C/B/B-Y BNC Connector
Connects to the RGB (connect all 3 connectors: CV/R/R-Y, G/Y,
and C/B/B-Y),
or YUV (connect all 3 connectors: CV/R/R-Y, G/Y, and C/B/B-Y),
or RGBS (connect all 3 connectors: CV/R/R-Y, G/Y, and C/B/B-Y,
and SYNC)
video acceptor
26 SETUP Dipswitches Dipswitches setup (see section 6.2)
27 RS-232 Port Connects to the PC or the Remote Controller
28 Power Connector with Fuse AC connector enabling power supply to the unit
1 Insert a screwdriver into the small hole and carefully rotate it, trimming the level
2 Press for about 2 seconds to lock/unlock the panel
3 Push in to terminate the input. Release when the input extends to another unit