User's Manual

The Kramer T5F-13 Inner Frame

Congratulations on purchasing your Kramer T5F-13 inner frame for the TBUS-5xl Table

Connection bus.

The T5F-13 inner frame includes:

• An opening for 1 power socket • 1 cable pass-through insert

• 2 blank inserts

Figure 1: T5F-13 Inner Frame (P/N: 80-004099)

Power Socket and Power Cord Options

Various power sockets and power cords are available to use with the T5F-13, as described in

the “TBUS Modular Power Socket Installation and Power Cord” Installation Instructions,

supplied with the power socket.

Each power socket comes with detailed assembly instructions.

The T-2INSERT Kit Option (80-00006699)

You can install the T-2INSERT kit (which includes 1 pass-through insert and a blank insert)

instead of a power socket.

Mounting the Inserts

Go to http://www.kramerelectronics.com to check for up-to-date

user manuals and the complete list of Kramer wall plates and

module connectors.

You can rearrange or remove any of the plates mounted on the inner frame and replace them

with Kramer passive wall plates or connector modules for interfacing A/V type signals.

To mount a Kramer insert or connector module:

1. Unscrew the two screws that fasten the blank plate to the inner frame and remove the

blank plate.

2. Place the required Kramer insert over the opening, insert the two screws to fix the

Kramer insert in place, and tighten them.

Installing the Assembled Inner Frame

To install the T5F-13 inner frame:

1. Place the assembled inner frame inside the TBUS-5xl enclosure.

2. Set the required height using your fingers to bring the inner frame to the desired

position, screw and tighten it in place using the height adjustment screws supplied with

the inner frame.

Connecting the Cables

When replacing blank inserts with connector inserts (for example, VGA, audio, HDMI and so

on):

1. Insert the cables to their appropriate connectors from underneath.

2. Secure the cables to the tie holes on the TBUS-5xl.

Do not secure the cables too tightly or too loosely. Leave a small amount of slack.

After the TBUS-5xl is connected to mains power and the proper cables, it is ready for use.

PAGE 1
Mounting the Inserts The Kramer T5F-13 Inner Frame Congratulations on purchasing your Kramer T5F-13 inner frame for the TBUS-5xl Table Connection bus. You can rearrange or remove any of the plates mounted on the inner frame and replace them The T5F-13 inner frame includes: • An opening for 1 power socket • 2 blank inserts i Go to http://www.kramerelectronics.com to check for up-to-date user manuals and the complete list of Kramer wall plates and module connectors.
PAGE 2
Inserting Pass-through Cables KRAMER ELECT RONICS LT D. To insert the pass-through cables (for example, to connect a laptop) do the following: 1. Remove the two screws attaching the split pass-through bracket. 2. Remove the split grommet(s). 3. Insert the cable(s) through the rectangular opening. 4. Open the split grommet slightly and insert the required cables. 5. Place the split bracket around the grommet and position this assembly over the inner frame. 6.