Instruction Manual

Using the XGA Line Transmitter(s) / Receiver
11
5.1 Installing the WP-110 XGA Line Transmitter
To install your WP-110 XGA Line Transmitter:
1. Connect the LINE OUT RJ-45 connector to the pre-installed UTP wiring
in the wall box opening that connects via UTP cabling to the LINE IN
RJ-45 connector of the PT-120 or TP-120.
2. Connect your 12V DC power supply to the POWER SUPPLY pins
1
,
taking care that polarity is correct.
3. Insert the WP-110 directly into the wall box opening, and then mount
the front panel securely using the screws.
4. Connect the XGA source to the XGA IN 15-pin HD (F) connector.
5.2 Wiring the CAT 5 LINE IN / LINE OUT RJ-45 Conne
ctors
Table 5
and Figure 6 define the CAT 5 PINOUT, using a straight pin-to-pin
cable with RJ-45 connectors:
Table 5: CAT 5 PINOUT
Figure 6: CAT 5 PINOUT
EIA /TIA 568A EIA /TIA 568B
PIN Wire Color PIN Wire Color
1 Green / White 1 Orange / White
2 Green 2 Orange
3 Orange / White 3 Green / White
4 Blue 4 Blue
5 Blue / White 5 Blue / White
6 Orange 6 Green
7 Brown / White 7 Brown / White
8 Brown 8 Brown
Pair 1 4 and 5 Pair 1 4 and 5
Pair 2 3 and 6 Pair 2 1 and 2
Pair 3 1 and 2 Pair 3 3 and 6
Pair 4 7 and 8 Pair 4 7 and 8
1 Connect the wire labeled “+” to the +12V pin, and the wire labeled “–” to the GND pin