Owner manual

SL-14RC/N - Defining the Remote Control Panels 9
Note: The rotary switch configuration is only read at switch on. Therefore, when
changing the rotary switch position, you must switch off the SL-14RC/N and then
switch it on again for the new settings to take effect.
For connecting the RC-3TB, see Section
7.3.
5.2 Defining the RC-3TBU Remote Control Panel
Figure 3 defines the RC-3TBU.
Figure 4: RC-3TBU Remote Control Panel Components
# Feature Function
1 Mounting Holes 2 holes for mounting the RC-3TBU to the PTBUS-3 or
TBUS-6W
2 Buttons 1 to 3 Function assignment is performed using the configurator
software
3 K-NET Connector Connect to either SL-14RC/N or additional RC-3TB/U
devices
4 USB Connector For connecting to the programming PC