Owner manual

14 SL-14RC/N - Connecting the SL-14RC/N
To connect the SL-14RC/N to a network:
1. Connect the Ethernet port of the SL-14RC/N to the Ethernet port on a
network hub or network router, via a straight cable with RJ-45 connectors.
2. At the other end, connect the Internet to a PC running Site-CTRL.
3. After connecting the Ethernet port, you have to install and configure it. For
detailed instructions on how to install and configure your Ethernet port, see
the K-Config Software Guide available from our Web site at
www.kramerelectronics.com
.
7.3 Connecting RC-3TB/U Remote Control Panels
(Optional)
One or more RC-3TB/U panels may be connected to the K-NET port on the
SL-14RC/N in a daisy-chain configuration.
The wiring from a K-NET port to a single RC-3TB/U is shown in
Figure 7.
Figure 7: K-NET to RC-3TB/U Connection
7.3.1 Terminating RC-3TB/U Remote Control Panels
If only one RC-3TB/U is connected, it must be terminated and the termination on
the SL-14RC/N is turned off (see Section
5). When viewed from above and the
rotary switch is to the left of the termination switch, slide the termination switch to
the left as shown in
Figure 7.
Only the last RC-3TB/U in the chain should be terminated.