Owner's manual

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Using Your Room Controller
12
Table 9 summarizes the room controller functions and characteristics.
Table 9: Room Controller Functions and Characteristics
Master Standalone Auxiliary
K-NET Connector(s) Connects to up to
two auxiliary devices
– Connects to the master
device
Connects to controlled machines Yes Yes Yes
Requires power supply Yes Yes No, receives power from
the Master Controller
Requires Programming
1
Yes Yes No, receives commands
from the Master controller
Figure 7 defines the power supply pinout for Master and standalone room
controllers:
Figure 7: RC-63D Master/Standalone Power Supply Pinout
Figure 8 and Table 10 define
2
Figure 8
a standalone room controller. If the room controller
is configured to be a Master room controller, up to two auxiliary devices can be
connected via the two K-NET terminal block connectors (not shown in ).
1 Refer to the separate K-Config online configuration software technical documentation at http://www.kramerelectronics.com
2 Your room controller was installed and configured to suit your specific requirements. This example describes how to setup
one of an unlimited number of available setups for the system