Owner manual

Creating a Macro

10.2 Adding Commands to the Macro

Each room controller includes a different set of commands, as defined in

Table 1. The following sections describe how to write a new command for the

different ports.

10.2.1 A Relay Command – Turn Lights ON

To write a relay command on an RC button (for example, turn the lights on),

do the following:

1. Open the Kramer RC Configuration main window.

2. Select a button from the RC buttons layout.

The button turns green.

3. Click the New button (in the Button Macro area) to add a new command to the

Button Macro.

4. In the RC command area, write the command description (for example, Lights

ON).

5. Select the Port

6. Select the relay command (for example, Close).

you want to assign (for example, RELAY_1)

Figure 32 illustrates the RC Command area as it appears after writing the

command:

Figure 32: Lights ON RC Command

1 When selecting a relay as a port, the Vendor, Device and Revision drop down boxes disappear and the Driver command

drop down box is replaced with a Relay Command drop down box