User guide
Table Of Contents
- 1 Introduction
- 2 Getting Started
- 3 Overview
- 4 Defining the SID-X2N Step-in Commander
- 5 Connecting the SID-X2N
- 6 Principles of Operation
- 7 Operating the SID-X2N
- 8 Configuring and Maintaining the SID-X2N
- 9 Wiring the Twisted Pair RJ-45 Connectors
- 10 Technical Specifications
- 11 Default EDID
- 12 Protocol 3000
10
SID-X2N - Connecting the SID-X2N
To connect a remote step-in switch and LED as illustrated in the example in Figure 4:
1. Connect pins 2 and 3 from the terminal block to the remote step-in switch.
2. Connect pin 1 from the terminal block to the anode of the remote step-in
LED.
3. Connect pin 3 from the terminal block to the cathode of the remote step-in
LED.
5.2 Connecting the Remote Select Switch and LED
You can connect a remote, contact closure, input selection switch to activate an
input (momentary contact is sufficient to switch inputs), as well as an indicator
LED to the terminal block on the rear panel of the SID-X2N.
Figure 5 illustrates the connections from the terminal block to the switch and LED.
Figure 5: Remote Select Switch and LED Wiring
To connect a remote selection switch and LED as illustrated in the example
in Figure 5:
1. Connect pins 2 and 3 from the terminal block to the remote selection switch.
2. Connect pin 1 from the terminal block to the anode of the remote selection
LED.
3. Connect pin 3 from the terminal block to the cathode of the remote selection
LED.