User guide
Table Of Contents
- 1 Introduction
- 2 Getting Started
- 3 Overview
- 4 Defining the SID-X2N Step-in Commander
- 5 Connecting the SID-X2N
- 6 Principles of Operation
- 7 Operating the SID-X2N
- 8 Configuring and Maintaining the SID-X2N
- 9 Wiring the Twisted Pair RJ-45 Connectors
- 10 Technical Specifications
- 11 Default EDID
- 12 Protocol 3000
SID-X2N - Connecting the SID-X2N
11
11
5.3 Connecting the Remote Input Selection LEDs
You can connect remote, input selection LEDS to the LED terminal block on the
rear panel of the SID-X2N to indicate which is the active input.
Figure 6 illustrates the connections from the terminal block to the LEDs.
Figure 6: Remote Input Indicator LED Connections
To connect remote input indicator LEDs:
1. Connect pin 1 from the terminal block to the anode of the remote HDMI
indicator LED.
2. Connect pin 2 from the terminal block to the anode of the remote DP
indicator LED.
3. Connect pin 3 from the terminal block to the anode of the remote DVI
indicator LED (see the example in Figure 7).
4. Connect pin 4 from the terminal block to the anode of the remote UXGA
indicator LED.
5. Connect pin 5 from the terminal block to the cathode of each LED.
Figure 7: Example of a Remote Input Indicator LED Wiring for the DVI Input