Manual

SID-X3N - Operating the SID-X3N

7 Operating the SID-X3N

This chapter describes the operating procedures of the SID-X3N and comprises:

 Manually selecting an input (see Section 7.1)

 Taking control of the switcher input (see Section 7.2)

 Locking the EDID (see Section 7.3)

 Audio mode selection (see Section 7.4)

Powering up the SID-X3N recalls the last settings (that is, the configuration of the

device when it was powered down) from the non-volatile memory.

7.1 Manually Selecting an Input

Note: When the button is lit it is inactive and pressing the button will not activate

the input

To manually select an input:

 Press the INPUT SELECT button repeatedly until the required input is active

as indicated by the associated LED

Note: The manual selection overrides the video selection mode set when in last

connected mode and remains in effect until the device is power cycled.

7.2 Taking Control of the Switcher Input When Connected

to the VS-62H

To activate the input of the VS-62H to which the SID-X3N is connected, press the

STEP-IN button. If the VS-62H grants the SID-X3N access to the input, the STEP-

IN button lights. If the VS-62H does not grant access for some reason, the button

flashes for a few seconds and then does not light. This may be because the

VS-62H input connected to the SID-X3N has been set to have a lower priority than

the currently active input.

Note: Input priority on the VS-62H is set using the Kramer Control Software.