Owner's manual
KRAMER: SIMPLE CREATIVE TECHNOLOGY
Defining the Wall Plates (U.K. and Europe)
18
5.7 SV-306 (U.K. and Europe)
The SV-306 is a single-gang wall plate
and has a terminal block and power
connector at the rear.
The SV-306 provides EDID PassThru and HDCP support
(passes EDID signals
from source to display).
In order to operate the IR when no HDMI signal is present, the HDMI cable must
be connected between the source and the SV-306.
Note: The SV-306 uses special twisted pair cable (see
Section
Table 15 defines the front and rear views of the SV-306.
Table 15: SV-306 (U.K and Europe)
1
Front and Rear View
SV-306 Front View
SV-
306 Rear View
# Feature Function
1 ON LED
Lights red when receiving power (when no signal is detected); lights green
when receiving a signal
2 HDMI IN Connector Connect to the HDMI digital source
3 IR OUT 3.5mm Mini
Connector
Connect to a machine via an IR Emitter
4 Terminal Block Connect to SV-552. Note that the SV-306
requires BC
BC-DGKat-623 cable for connection
5 GROUND Connection Ring tongue terminal and grounding screw
6 GND +12V 2-pin Power
Terminal Block
Connect to an optional 12V power supply
1 When mounting in Belgium and Germany, use the standard WP Adapter
KRAMER: SIMPLE CREATIVE TECHNOLOGY
and has a terminal block and power
(passes EDID signals
In order to operate the IR when no HDMI signal is present, the HDMI cable must
Section
6.1).
Front and Rear View
306 Rear View
Lights red when receiving power (when no signal is detected); lights green
requires BC
-DGKat524 or