Owner's manual

KRAMER: SIMPLE CREATIVE TECHNOLOGY
The RC Configuration Software
6
The following sections describe how to:
• Install the software (see section
4.1)
• Download the device drivers (see section
4.2)
• Create Serial and IR commands (see section
4.3)
• Map the ports (see section
4.4)
• Use the Kramer RC Configuration main window (see section
4.5)
4.1 Installing the Software
Prior to using the Kramer RC-SV configuration software, make sure that the
“.NET Framework” Revision 2.0 software is installed on your PC. If it is not,
you need to install it:
• If you have a fast Internet connection, this software is automatically
installed during the installation of the Kramer RC-SV configuration
software
• If you do not have a fast Internet connection, insert the CD-ROM into the
CD-ROM drive, double click the dotnetfx.exe
1
file and follow the
on-screen instructions
2
Before getting started with your Kramer RC-SV configuration, you must
download the software and then install it. You can download it
3
1. Go to our Web site at
from the
Internet. To do so:
http://www.kramerelectronics.com and download the
file: “Kramer RC-SV Config.zip”
from the DOWNLOADS section.
2. Extract the file “Kramer RC-SV Config.zip” package, which includes the
Kramer RC configuration 2 application setup and the Kramer device drivers
4
3. Install the Kramer RC-SV Configuration application.
When running Setup, you are prompted to set the working directory (see
,
to a folder (for example, C:\Program Files\Kramer RC Configuration).
Figure 2):
1 File names are liable to change
2 Installation may take about 15 minutes
3 File names are liable to change from time to time
4 Mostly for matrix switchers and switchers