Instruction Manual

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Your TP-210A UXGA – Audio – RS-232 Line Transmitter/DA
6
Table 1: TP-210A
UXGA – Audio – RS-232 Line Transmitter/DA Features
# Feature Function
1 POWER Switch Illuminated switch for turning the unit ON or OFF
2 UXGA INPUT 15-pin HD Connector Connect to the video source
3 UXGA OUT 15-pin HD Connectors Connect to the video acceptor
1
4 LINE OUTPUT RJ-45 Connectors
1
Connect to
2
the LINE IN RJ-45 connector on a receiver
3
5
ANALOG AUDIO
3.5mm Mini Jacks
INPUT
Connect to the stereo analog audio source
6
OUT
Connect to the stereo analog audio acceptor
1
7 S/PDIF ANALOG Selector Button
4
Press to select the analog audio source
Release to select the S/PDIF source
8 S/PDIF RCA
Connectors
INPUT
Connect to the digital audio source
9
OUT
Connect to the digital audio acceptor
1
10 RS-232 Terminal
Block Connector
IN (G, Rx)
Connect the two connectors (G and Rx) to transmit a
command (see section 6.1
)
11 OUT (G, Tx
1
) Connect the two connectors (G and Tx) to control a device
(see section 6.1
)
12 Power Connector with Fuse AC connector enabling power supply to the unit
4.1 The TP-210A UXGA – Audio – RS-232 Line Transmitter/DA
Underside
Figure 2
and Table 2 define the underside of the TP-210A
Figure 2: TP-210A Underside
Table 2: Features of the TP-210A Underside
Feature Function
VS Switch
5
Slide the switch up, to set the VS to negative polarity (NEG.)
Slide the switch down, to set the VS to its input polarity (NORM.)
HS Switch
5
Slide the switch up, to set the HS to negative polarity (NEG.)
Slide the switch down, to set the HS to its input polarity (NORM.)
1 From 1 to 2
2 Using a UTP CAT 5 cable with RJ-45 connectors at both ends (the PINOUT is defined in Table 3
and Figure 4)
3 For example, the Kramer TP-124 or TP-46
4 RS-232 can be embedded only when the S/PDIF ANALOG Selector Button is set to the analog state
5 By default, both switches are set to NORM.