User guide

Connecting the TP-219HD and TP-220HD
9
3. On the TP-220HD, connect
1
the:
 OUTPUT 1 15-pin HD connector to an XGA
2
acceptor (for
example, Display 1)
 OUTPUT 2 15-pin HD connector to an XGA
2
acceptor (for
example, Display 2)
4. If necessary, set the HS and VS switches on the TP-220HD underside
3
.
5. Connect the LINE OUT RJ-45 connector on the TP-219HD to the LINE IN
RJ-45 connector on the TP-220HD, via CAT 5 cabling, see section 5.2
.
6. Connect the 12V DC power adapter to the power socket and connect the
adapter to the mains electricity on both
4
the TP-219HD and the TP-220HD
(not shown in Figure 5
).
The selected signal from the XGA/HD source is transmitted via CAT 5
cable, decoded and converted at the OUTPUT 1 and OUTPUT 2 15-pin
HD connectors to the XGA acceptors simultaneously.
1 You do not have to connect both outputs
2 Alternatively, you can connect an HD acceptor, see section 5.1
3 By default, both switches are set to normal (see Figure 4
and Table 4)
4 If you cannot connect the power to both the TP-219HD and TP-220HD, you can just connect the power to one of them