User Manual

TP-410 - The SETUP DIP-switches 19

7 The SETUP DIP-switches

The DIP-switches on the TP-410 set the machine number of the unit.

Moving a DIP-switch down turns the switch on, moving it up turns the

switch off. Changing any DIP-switch requires that you turn the TP-410

power off and then on again.

7.1 Setting the Machine Number

To control a unit remotely via RS-232, RS-485 or the Ethernet, each unit has to be

identified via its unique machine #. DIP-switches 1, 2, 3 and 4 set the machine

number (according to the table below).

Figure 12: The Address # DIP-switches

Add. #

DIP 1

DIP 2

DIP 3

DIP 4

Add. #

DIP 1

DIP 2

DIP 3

DIP 4

1 OFF OFF OFF OFF 9 OFF OFF OFF ON

2 ON OFF OFF OFF 10 ON OFF OFF ON

3 OFF ON OFF OFF 11 OFF ON OFF ON

4 ON ON OFF OFF 12 ON ON OFF ON

5 OFF OFF ON OFF 13 OFF OFF ON ON

6 ON OFF ON OFF 14 ON OFF ON ON

7 OFF ON ON OFF 15 OFF ON ON ON

8 ON ON ON OFF

When using a single unit, set the unit to Address # 1.

Do not use the 1111 DIP-switch combination for normal operation

(see

Section 10

After setting a new machine number, turn the power off and then on again.

)