User Manual

20 TP-410 - The SETUP DIP-switches

7.1.1 ETH Configuration

To configure the Ethernet parameters, set DIP-switches 1 to 4 to ON (ON-ON-ON-

ON), turn the power off and then turn the power on again.

Use the Kramer K-UPLOAD software to configure the Ethernet.

The latest version of K-UPLOAD and installation instructions can be

downloaded from the Kramer Web site at

www.kramerelectronics.com

7.2 Setting the RS-232/RS-485 Baud Rate DIP-switches

DIP-switches 5, 6 and 7 set the serial port baud rate.

In a multiple device configuration, all devices must be set to the same

baud rate.

Figure 13: TP-410 Baud Rate DIP-switches

Baud Rate

DIP-switch

5 6 7

1200 OFF OFF OFF

2400 ON OFF OFF

4800 OFF ON OFF

9600 (default) ON ON OFF

19200 OFF OFF ON