User Manual

TP-410 – Overview 6
Figure 2: TP-410 UXGA-Audio-RS-232 Line Transmitter / DA Rear Panel
# Feature Function
8
EDID STATUS LED Lights during normal operation; blinks when acquiring the EDID
9
CAPTURE Button Press to acquire the EDID information from the display (see Section 9
10
)
AUDIO
OUT
ANALOG 3.5mm Mini
Connector
Connect to an unbalanced stereo audio local acceptor to monitor any audio source
11
S/PDIF LOOP RCA Connector Connect to a digital audio local acceptor to monitor any audio source
12
AUDIO
INPUTS
S/PDIF AUDIO RCA Connector Connect to the selectable digital audio source
13
ANALOG AUDIO 3.5mm Mini
Connector
Connect to the selectable unbalanced stereo audio source
14
TP IN EQ. Trimmer Adjusts the cable compensation (equalization) level for the UXGA (RJ-45 TP input)
Degradation and VGA/XGA signal loss can result from using long cables (due to the effects of
stray capacitance, for example), sometimes leading to a loss of sharpness in high-resolution
signals
Use a screwdriver to carefully rotate the trimmer, adjusting the appropriate level
15
LEVEL Trimmer Adjusts the output signal level for the UXGA (RJ-45 TP input)
Use a screwdriver to carefully rotate the trimmer, adjusting the appropriate level
16
RJ-45 Connector Connect to the LINE OUT connector of a transmitter (the PINOUT is defined in Section 8
17
),
for example, the TP-125EDID
OUT 15-pin HD Connector Connect to a local display to monitor any computer graphics source
18
UXGA IN 15-pin HD Connector Connect to a computer graphics source
19
TP OUTPUTS RJ-45 Connectors
Connect to the LINE IN RJ-45 connector on a receiver, for example, the TP-126 (from 1
to 10)
Using a UTP CAT 5 cable with RJ-45 connectors at both ends (the PINOUT is defined in
Section 8
20
)
RS-232 (Tx, Rx, G) Connect to the RS-232 controller (PINs 2, 3 and 5 of a standard 9-pin D-sub connector –
see
Section 5.2)