User manual
KRAMER: SIMPLE CREATIVE TECHNOLOGY
Your TP-575 HDMI Line Receiver / DA
6
4 Your TP-575 HDMI Line Receiver / DA
Figure 1 and Table 1 define the TP-575 HDMI Line Receiver / DA:
Figure 1: TP-575 HDMI Line Receiver / DA
Table 1: TP-575 HDMI Line Receiver / DA Features
#
Feature
Function
1 EDID SETUP Button Press briefly to determine the type of EDID stored in the non-
volatile memory
Press and hold to select the desired EDID setup and then release
to acquire EDID (see section
5.3)
2 IN LED Illuminates when an input is connected
3 OUT 1 (LINE) LED Illuminates when OUT 1 is connected and active
Blinks when the monitor does not support HDCP
1
4
OUT 2 (HDMI) LED Illuminates when OUT 2 is connected and active
Blinks when the monitor does not support HDCP
1
5 ON LED Illuminates when receiving power
6 LINE IN RJ-45 Connector
Connects to the CAT 5 OUT RJ-45 connector on the PT-571
7 OUT 1 (LINE) RJ-45 Connector
Connects to the CAT 5 IN RJ-45 connector on the PT-572+
8 OUT 2 (HDMI) Connector Connects to the HDMI acceptor
9 12V DC +12V DC connector for powering the unit
5 Using the TP-575 HDMI Line Receiver / DA
This section describes how to:
• Connect the TP-575 (see section
5.1)
• Wire the twisted pair RJ-45 connectors (see section
5.2)
• Use the EDID SETUP button (see section
5.3).
1 This LED also illuminates or blinks during EDID setup (see section 5.3)