Manual

Connecting a VM-1045 Video Component Distributor
7
6 Connecting a VM-1045 Video Component Distributor
To connect the VM-1045 as illustrated in the example in Figure 3, do the
following
1
:
1. Connect a component video source (for example, an RGBS camera) to
the INPUT connectors.
2. Connect the LOOP BNC connectors (from channel A to channel D) to
the INPUT BNC connectors
2
on the next VM-1045 machine.
3. Connect the OUT 1 connectors of each channel
3
to the acceptor (for
example, RGBS display 1).
4. Connect the OUT 5 connectors of each channel
3
to the acceptor (for
example, RGBS display 5).
5. Connect the power cord
4
(not shown in this illustration).
6. If required, on the machine underside, for each channel, adjust the:
 EQ.
 LEVEL
1 Switch OFF the power on each device before connecting it to your VM-1045. After connecting your VM-1045, switch on
its power and then switch on the power on each device. Switching on the VM-1045, recalls the previous setup from the non-
volatile memory
2 On each channel
3 You do not need to connect all the outputs
4 We recommend that you use only the power cord that is supplied with this machine