Owner's manual

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Default Communication Parameters
38
12 Default Communication Parameters
Table 6 lists the default communication parameters as used in Kramer
Electronics products.
Table 6: Communication Parameters
EDID
EDID data is passed between Input 1 and Output 1
RS-232
Protocol 2000 Protocol 3000 (Default)
Baud Rate: 9600 Baud Rate: 115,200
Data Bits: 8 Data Bits: 8
Stop Bits: 1 Stop Bits: 1
Parity: None Parity: None
Command Format: HEX Command Format: ASCII
Example (Output 1 to Input 1): 0x01, 0x81, 0x81, 0x81 Example (Output 1 to Input 1): #AV 1>1<CR>
Switching Protocol
P2000 -> P3000 P3000 -> P2000
Command: 0x38, 0x80, 0x83, 0x81 Command: #P2000<CR>
Front Panel: Press and hold Output 1 and
Output 3 simultaneously
Front Panel: Press and hold Output 1 and
Output 2 simultaneously
Ethernet
To reset the IP settings to the factory reset values, power cycle the device while holding in the Factory
Reset button, located on the rear panel of the unit
IP Address: 192.168.1.39
Subnet mask: 255.255.255.0
Default gateway: 192.168.1.1
TCP Port #: 5000
UDP Port #: 50000
Maximum UDP Ports: 10
Maximum TCP Ports: 4
13 Factory Default EDID
Monitor
Model name VP-16X18AK
Manufacturer KRM
Plug and Play, ID KRM0808
Serial number 2
Manufacture date 2009, ISO week 10
EDID revision 1.3
Input signal type Analog 0.700, 0.000 (0.7 Vp-p)
Sync input support Separate, Composite, Sync-on-green
Display type RGB color
Screen size 360 x 290 mm (18.2 in)
Power management Standby, Suspend, Active off/Sleep
Extension blocs None
DDC/CI Not supported
Color characteristics
Default color space sRGB
Display gamma 2.0
Red chromaticity Rx 0.611 - Ry 0.329