Instruction Manual

Operating the VP-27 Presentation Switcher
11
11
7 Operating the VP-27 Presentation Switcher
The VP-27 operates in the audio-follow-video
1
You can select the video signals within each switcher group by pressing the
relevant INPUT SELECTOR
(AFV) mode so that the audio
signal follows the selected input signal.
2
• One
buttons. You can switch:
3
• One of the four s-Video (Y/C) inputs to the s-Video output
of the four composite video VIDEO (CV) inputs to the composite
video output
• One of the four PC inputs to the PC output of the VP-27
The selected button in each group is illuminated in red
4
An audio input can be switched to the master audio output either by pressing
any INPUT SELECTOR (in any group) button or by selecting a MASTER
AUDIO SELECTOR button (CV, Y/C, PC or MIC), which will route the
input signal of the selected group to the master audio output.
.
For example:
• Press INPUT SELECTOR button 2 in the PC group to switch that input
button to the master audio output
• Press IN 1 in the VIDEO (CV) group to route that input to the master
audio output
• If the s-VIDEO (Y/C) IN 2 button is selected, press the MASTER SUDIO
SELECTOR Y/C button to rout that input to the master audio output
The MUTE and MIX functions can be toggled and their respective buttons on
the front panel illuminate.
1 In which all operations relate to both the video and the audio channels
2 You can overlook a switcher group and choose not to select a button from it
3 You cannot select more than one button in a section
4 Pressing an illuminated button for more than 2 seconds will disconnect the output and the button will no longer illuminate