Owner manual




Figure 5: Typical VS-2000 System Setup
9.4.2 DIP Switches
The VP-61RS selects one of 6 VGA/Super-VGA/XGA standard signals. As said before there are two options
for operating the switcher, both are available without removing the switcher cover.
 It can be operated by touching one of the front panel switches.
 It can be operated by a remote PC via the RS-232 connectors on its rear panel.
The DIP switch (see Table 4) on the rear panel is used when the switcher is operated via the RS-232 connector
or when it is interconnected with other switchers. These switches allow proper configuration of the control
signals received/transmitted through the RS-232 control port. The VP-61RS allows master/slave
configurations so that the switchers may operate independently, or in conjunction with each other.