User manual

VP-422 - Connecting the VP-422

4 Connecting the VP-422

Always switch off the power to each device before connecting it to

your VP-422. After connecting your VP-422, connect its power and

then switch on the power to each device.

To connect the VP-422, as illustrated in the example in Figure 2, do the following:

1. Connect an HDMI source (for example, a camera) to the HDMI INPUT

connector.

Make sure that the HDMI source is not HDCP encrypted – if copy protection is

detected, the unit’s output will be switched off

2. Connect the PC OUTPUT 15-pin HD connector to a computer graphics or

HDTV acceptor as follows:

 When connecting to an XGA acceptor (RGBHV), then connect to the

acceptor’s XGA connector

 When connecting to a component acceptor (Y,Pb,Pr), then connect as

follows:

PIN #

Signal

6, 7, 8

Ground

3. Connect the L and R audio OUTPUT RCA connectors to an analog stereo

audio acceptor (for example, a power amplifier with speakers).

4. Connect the 5V DC power adapter to the power socket and connect the

adapter to the mains electricity (not shown in Figure 2).