User manual

8
VP-424 - Controlling the VP-424
5.1.1 The MAIN MENU
Mode
Function
PICTURE
CONTRAST – set the contrast
BRIGHTNESS – set the brightness
SATURATION – set the saturation
HUE – set the hue
SHARPNESS – set the sharpness
RESET PICTURE – reset all the picture parameters to their default
value
ASPECT RATIO
FULL, 16:9, 4:3 or BEST FIT
OVER SCANNING
OFF, 5%, 10%, 15% or 20%
NOISE REDUCTION
OFF, MIN, TYP or MAX
OUTPUT
Select an output resolution from the menu (default 720p):
Output resolution:
Appears as:
Output resolution:
Appears as:
Native
1280x800
1280x800
480p
480P
1280x1024
SXGA
576p
576P
1360x768
WXGA
720P
720P
1400x1050
1400x1050
1080i
1080I
1440x900
WSXGA
1080p
1080P
1600x900
1600x900
640x480
VGA
1600x1200
UXGA
800x600
SVGA
1680x1050
1680x1050
1024x768
XGA
1920x1200(RB)
WUXGA
NATIVE – Set to Native to select the output resolution from the EDID of the
connected HDMI monitor
HD OUTPUT COLOR
Select the HD output colorspace: RGBHV or YPbPr
REFRESH RATE
Select the output refresh rate: 60Hz, 50Hz or FOLLOW (follow the
input refresh rate)
OSD SETTINGS
Set the OSD parameters: H Position, V Position, Timeout
Transparency and Display (see Section 5.1.2)
ADVANCED
AUTO SYNC OFF: Turn the auto sync ON/OFF. When ON, this de-
activates the output after a few minutes if no input is present.
This is useful, for example, when the output is connected to a projector,
and the projector will automatically shut down when it has no input
HDCP ON INPUT: Select the HDCP option for the HDMI input: either
ON (the default) or OFF.
Setting HDCP support to disabled (OFF) on the HDMI input allows the
source to transmit a non-HDCP signal if required (for example, when
working with a Mac computer)
FREEZE: Set the front panel FREEZE button behavior to FREEZE
ONLY, FREEZE&MUTE or MUTE ONLY
FACTORY DEFAULT
Resets to the default parameters (resolution is set to XGA or 720p)
If you cannot see the display after factory reset, use the front panel buttons
to set the correct resolution (as indicated on the panel):
To reset to XGA, press the FREEZE (+) and ENTER buttons
simultaneously for about 2 seconds To reset to 720p, press the – and
MENU buttons simultaneously for about 2 seconds
INFORMATION
Displays the input resolution, output resolution and the software version