Owner's manual

VP-4x1CS - Operating the VP-4x1CS 4x1 PC Graphics Clean Switcher

7 Operating the VP-4x1CS 4x1 PC Graphics

Clean Switcher

The VP-4x1CS can be operated:

 Locally using the front panel buttons (see Section 7.1)

 Remotely using:

 The embedded Web pages (see Section 7.2)

 The K-Single Application (see Section 7.3)

7.1 Operating the VP-4x1CS Locally

This section describes:

 Setting a priority Input (see Section 7.1.1)

 Switching Between Protocol 2000 and Protocol 3000 (see Section 7.1.2)

 Locking and unlocking the front panel buttons (see Section 7.1.3)

 Resetting the device to factory default settings (see Section 7.1.4)

 Upgrading the VP-4x1CS firmware (see Section 7.1.5)

 EDID Handling (see Section 7.1.6)

7.1.1 Setting a Priority Input

When a priority input is set, the VP-4x1CS cycles through the inputs from 1 to 4

(beginning with the priority input) looking for a live signal. If there is no signal on

the priority input the device cycles through the inputs (from low to high) and

selects the first input that is encountered with a live signal.

Note: When a priority Input is selected, the device does not perform clean

switching.

Note: For clean switching, all extracted sources must be of the same resolution.