User manual

VP-553 - Connecting the VP-553

5 Connecting the VP-553

Always switch off the power to each device before connecting it to

your VP-553. After connecting your VP-553, connect its power and

then switch on the power to each device.

You do not have to connect all the inputs and outputs, connect only

those that are required.

To connect the VP-553, as illustrated in the example in Figure 3, do the following:

1. Connect an HDMI source (for example, a DVD player) to the HDMI VIDEO

INPUT connector (from 1 to 3).

Alternatively, you can connect the DVI connector on the DVD player to the HDMI

connector on the VP-553 via a DVI-HDMI adapter. When using this adapter, you can

connect the audio signal via the terminal block connector

2. Connect a computer graphics source to the PC 1 15-pin HD VIDEO INPUT

connector (from 1 to 2).

3. Connect a composite video source (for example, a composite video player)

to the CV VIDEO INPUT RCA connector (from 1 to 2).

4. Connect a TP transmitter (for example, TP-121xl) to the RJ-45 TP IN

connectors (from 1 to 2).

5. Connect an HDBT transmitter (for example, TP-580T) to the RJ-45 TP IN

connectors (from 1 to 3).

6. Connect the USB IN ports (from 1 to 4) (for example, a PC) and USB OUT

port (for example, a smart whiteboard).

7. Connect the audio inputs (not shown in Figure 3) to the:

 HDMI audio input 3.5mm mini jacks (from 1 to 3)

 PC audio input 3.5mm mini jacks (from 1 to 2)

 CV audio inputs to the L and R RCA connectors (from 1 to 2)