Owner's manual

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Your VP-6A 1:6 UXGA / Audio / +1 CAT5 Distributor
6
Table 1: Front and Rear Panel Features of the VP-6A
# Feature Function
1 POWER Switch Illuminated switch for turning the unit ON or OFF
2 UXGA EQ. Trimmer Adjusts
1
the video EQ. (equalization) compensation
3 LEFT Trimmer Adjusts
1
the left output signal level
4
AUDIO
LEVEL
RIGHT Trimmer Adjusts
1
the right output signal level
5 BAL. AUDIO INPUT Terminal Block
Connector
Connect to the balanced stereo audio source
6 UXGA INPUT HD15F Connector Connect to the computer graphics (UXGA) source
7 UNBAL/BAL IN SELECT Button Selects balanced stereo audio when released; selects
unbalanced stereo audio when pushed in
8 UNBAL. AUDIO IN 3.5mm Mini Jack Connect to the unbalanced stereo audio source
9 BALANCED AUDIO OUT Terminal
Block Connectors
Connect to the balanced stereo audio acceptors (from 1 to 6)
10 UXGA OUT HD15F Connectors Connect to the computer graphics (UXGA) acceptors (from 1 to 6)
11 UNBALANCED AUDIO OUT 3.5mm
Mini Jacks
Connect to the unbalanced stereo audio acceptors (from 1 to 6)
12 LINE OUT RJ-45 Connector Connect to
2
the LINE IN RJ-45 connector on a Kramer CAT5
receiver
3
13 Power Connector with Fuse AC connector enabling power supply to the unit
Figure 2 and Table 2 define the underside panel switches of the VP-6A:
Table 2: Underside Features of the VP-6A
# Feature Function
1 VS
4
Switch
Slide the switch to the right
5
to change
the VS polarity to negative polarity
6
;
slide the switch to the left (Normal) to
retain the polarity
2 HS
4
Switch
Slide the switch to the right
5
to change
the HS polarity to negative polarity
6
;
slide the switch to the left (Normal) to
retain the polarity
3 ID BIT 4
Switch
Slide to the left to set to ON
7
; to the
right to set to OFF
4 ID BIT 11
Switch
Slide to the left to set to ON
7
; to the
right to set to OFF
Figure 2: Underside of the VP-6A
1 Insert a screwdriver into the hole and carefully rotate it, to trim the level
2 Using a UTP cable with CAT5 connectors at both ends (the PINOUT is defined in Table 3 and Figure 6)
3 For example, on the TP-120 XGA Line Receiver. Refer to the separate user manual: PT-110, PT-120, TP-120, WP-110,
which can be downloaded at http://www.kramerelectronics.com
4 SYNC
5 By default, both switches are set to the left
6 Downgoing syncs
7 The default. Enabling the notebook or laptop to output a VGA signal to an external VGA monitor