User manual

3.2.

Introduction

The VP-792 units have the input connectors on one side of the housing and the output connector and

communication ports on the opposite side. The keypad for controlling VP-792 is located on the input

connectors side. The active input is indicated by their corresponding triangles lit green.

1 – Keypad with three keys for OSD menu navigation (Menu, Down and Up) and a key for input channel

selection (Input).

With the Menu key the OSD menu is activated. The up and down keys are used for OSD menu

navigation. To exit the OSD menu or any submenu navigate go to the Exit item and press the menu key.

To access a submenu navigate to it and press the menu key. To apply a change go to the menu item,

press the menu key and make a parameter change with the up and down key. Confirm the change by

pressing the Menu key. This will also bring you back to the submenu.

By pressing the Input button multiple times the available input channels are toggled through. The active

channel is indicated by the associated green lit triangle(s). The exception is that the test patterns are

selected through the menu/input

With the following multiple key presses further functions can be applied:

Keypad unlock: Up and Down

Set output and fallback output mode to VGA: Menu and Up

Mode reset: Menu and Down

Factory reset: Menu and Up and Down